• Banner image for: Banner image for:

Electronic

58 products


  • Parts Express Nickel Plated Nibbling Tool

    Parts Express Parts Express Nickel Plated Nibbling Tool

    Simply drill 3/8" hole insert cutting head and compress handles. Gives you the ability to make square holes for fuse holders, special connectors displays etc. Material to be nibbled is placed in the gap between the punch and blade channel. By squeezing the handles together, the punch will move down into the channel, cutting out a slug of metal. A scribe line can be followed by looking down on work in this position. A slot is cut by making successive cuts.

    $15.99

  • Parts Express Steel Mesh 2-Piece Grill for 8" Speaker Black

    Parts Express Parts Express Steel Mesh 2-Piece Grill for 8" Speaker Black

    Parts Express Steel Mesh 2-Piece Grill for 8" Speaker BlackConvenient and fast way to put grills on auto and PA equipment. 2-piece construction allows you to mount ring and woofer with one set of screws and snap the grill over the entire assembly. Installed screws are not visible. Screws and speed clips included. Heavy-duty expanded steel mesh design. Grill fits 8" speaker with a maximum outer diameter of 8-1/4". Overall diameter: 8-3/8". Sold individually.

    $16.99

  • Dayton Audio DAEX25FHE-4 Framed High Efficiency 25mm Exciter 24W 4 Ohm

    Dayton Audio Dayton Audio DAEX25FHE-4 Framed High Efficiency 25mm Exciter 24W 4 Ohm

    Small size; just under 2" diameter, about 7/8" high Pre-applied 3M™ VHB™ adhesive for quick, durable installation Rare-earth neodymium motor and a proprietary voice coil 4-ohm impedance for use with small, Class D amplifiers 24 watt RMS power handling for high output

    $17.99

  • Dayton Audio DAEX25CT-4 Coin Type 25mm Exciter 10W 4 Ohm

    Dayton Audio Dayton Audio DAEX25CT-4 Coin Type 25mm Exciter 10W 4 Ohm

    Small size; just under 2" diameter, about 9/16" high Pre-applied 3M™ VHB™ adhesive for quick, durable installation Rare-earth neodymium motor and a proprietary voice coil 4-ohm impedance for use with small, Class D amplifiers 1" voice coil for 10 watt RMS power handling

    $16.99

  • Dayton Audio PC68-4 2-1/2" Full-Range Poly Cone Driver

    Dayton Audio Dayton Audio PC68-4 2-1/2" Full-Range Poly Cone Driver

    Poly damped woven glass fiber cone controls cone break-up and provides a smooth roll-off High energy ferrite magnet increases BL for higher efficiency and increased output Rubber surround improves cone linearity and transients Smooth response with true full-range reproduction for simple speaker designs

    $16.99

  • Parts Express 8 Ohm 100W Non-Inductive Dummy Load Resistor

    Parts Express Parts Express 8 Ohm 100W Non-Inductive Dummy Load Resistor

    Non-inductive dummy load resistors are a must for bench testing amplifiers. Also useful for testing loudspeakers and other audio circuits requiring an 8 ohm load. 5% tolerance. Dimensions: 6-1/2" L x 1-9/16" W x 3/4" H; Inner width of the screw holes: 5.4 mm; Inside edge to inside edge measurement between the two screw holes: ~144 mm.

    $20.99

  • Pololu 2851 5V, 5A Step-Down Voltage Regulator D24V50F5

    Pololu Pololu 2851 5V, 5A Step-Down Voltage Regulator D24V50F5

    Input voltage: 4.5 V to 38 V for the version that outputs 3.3 V Fixed 3.3 V, 5 V, 6 V, 7.5 V, or 9 V output (depending on regulator version) with 4% accuracy Typical maximum continuous output current: 2.5 A Integrated reverse-voltage protection, over-current protection, over-temperature shutoff, and soft-start Typical efficiency of 85% to 95%, depending on input voltage and load; the switching frequency automatically changes at light loads to maintain high efficiencies

    $48.99

  • E3D Prusa Thermistor

    E3D E3D Prusa Thermistor

    A standard Semitec thermistor cartridge with a Prusa specific extension cable and connector. This is the same thermistor supplied directly to Prusa.

    $15.79

  • Tower MFG 30440003 Auto-Reset 15 AMP Grounded 3-Prong GFCI 5-Outlet Adapter

    Tower Mfg Tower MFG 30440003 Auto-Reset 15 AMP Grounded 3-Prong GFCI 5-Outlet Adapter

    RELIABLE PROTECTION - Protect users, tools, and equipment from electric shock with this durable GFCI adapter. INDOOR SAFETY - Add safety to interior outlets with this indoor-grade adapter. DURABLE 3-PRONG CONNECTIONS – The adapter features a NEMA 5-15P three-prong grounded plug and five NEMA 5-15R receptacles. DEPENDABLE PERFORMANCE - Independently-tested and UL- and CUL-listed for safe operation. LIGHTED POWER INDICATOR – Easily see that power is available with the "power on" indicator light.

    $24.99

  • E3D V6 Extra Nozzle 1.75mm x 0.60mm

    E3D E3D V6 Extra Nozzle 1.75mm x 0.60mm

    Genuine E3D V6 replacement nozzle for 1.75mm filament at .60 mm nozzle size. This premium quality E3D replacement nozzle allows you to truly customize each and every print. This high quality nozzle have been created using community feedback and notes over multiple revisions from E3D.

    $13.99

  • Posi-Twist® Wire Connector 18-26 Gauge

    Posi-Products® Posi-Twist® Wire Connector 18-26 Gauge

    Quick & Easy: Twist On / Twist Off with your hand. No need for cramp connectors. Affordable: Same superior connection as Posi-lock with cost saving. High Temperatures. Vibration Proof. No Metal Parts. For use with 18-26 gauge wires. Available in variety packs.

    $11.99

  • Posi-Lock® Assortment pack wire Connectors 10-24 AWG

    Posi-Products® Posi-Lock® Assortment pack wire Connectors 10-24 AWG

    Superior in-line crimp splices with just hand tightening! Temperature range of -23 degrees C to 120 degrees C. For use with 10-24 gauge wires. Available in variety packs.

    $11.99

  • Parts Express HDMI Cable Signal Tester

    Parts Express Parts Express HDMI Cable Signal Tester

    Easy to use; compact and portable Simply plug your cables into the tester''s DVI-F and HDMI-F connectors Diagnoses the cause of color shift, sparkle, or missing picture Tester can be located at the source or display end of the system Displays the status of each HDMI signal component

    $30.99

  • Dayton Audio BST-2 Tactile Bass Shaker 35 Watt

    Dayton Audio Dayton Audio BST-2 Tactile Bass Shaker 35 Watt

    Increase the realism of home theater and gaming systems for a more immersive experience Add low frequency tactile impact without ridiculous SPL levels Cast aluminum housing dissipates heat for reliable performance Attached 24” leads for easy connections in hard to reach installations Easy to install on any flat surface

    $38.99

  • Dayton Audio DAEX58FP Flat Pack 58mm Exciter 25W 8 Ohm

    Dayton Audio Dayton Audio DAEX58FP Flat Pack 58mm Exciter 25W 8 Ohm

    Super small size with low profile height 8 ohm impedance for use in almost any amplifier Includes mounting plate Adds sound to any surface

    $22.99

  • Dayton Audio DCS165-4 6-1/2" Classic Subwoofer 4 Ohm

    Dayton Audio Dayton Audio DCS165-4 6-1/2" Classic Subwoofer 4 Ohm

    4-layer VC with polyimide former allows high power handling Vented pole piece and bumped back plate provide plenty of VC travel with minimal compression Copper pole piece cap minimizes inductance Rigid non-pressed treated paper/Kevlar cone with rubber surround Great for home and automotive applications

    $70.99

  • Dayton Audio DC160-8 6-1/2" Classic Woofer

    Dayton Audio Dayton Audio DC160-8 6-1/2" Classic Woofer

    Great bang-for-the-buck driver can be used as a woofer, midbass, or even as a small subwoofer! Smooth frequency response up to 2 kHz and great bass response Rubber surround, aluminum voice coil, and extended bump plate Low 34 Hz free-air resonance

    $45.99

  • Parts Express Cable Pants 6mm 2-Conductor Black 10 pcs

    Parts Express Parts Express Cable Pants 6mm 2-Conductor Black 10 pcs

    Pack of 10 6 mm entry size, 3.5 mm conductor size Ideal when building your own speaker cables Add a professional look to your customized cables

    $10.49

  • Parts Express Cable Pants 10mm 2-Conductor Black 10 pcs

    Parts Express Parts Express Cable Pants 10mm 2-Conductor Black 10 pcs

    Pack of 10 10mm entry size, 4 mm conductor size Ideal when building your own speaker cables Add a professional look to your customized cables

    $9.99

  • Parts Express Cable Pants 8mm 2-Conductor Black 10 pcs

    Parts Express Parts Express Cable Pants 8mm 2-Conductor Black 10 pcs

    Pack of 10 8 mm entry size, 3.2 mm conductor size Ideal when building your own speaker cables Add a professional look to your customized cables

    $10.99

  • Dayton Audio iMM-6 Calibrated Measurement Microphone

    Dayton Audio Dayton Audio iMM-6 Calibrated Measurement Microphone

    Precision condenser microphone for critical measurement For use with any smartphone or tablet with a 3.5 mm TRRS headset jack True omnidirectional pattern with calibrated flat frequency response Headphone/Line Out pass-through jack for test signals or listening Kickstand feature elevates and angles device and microphone capsule

    $26.19

  • Pololu 1350 Micro Maestro 6-Channel USB Servo Controller (Assembled)

    Pololu Pololu 1350 Micro Maestro 6-Channel USB Servo Controller (Assembled)

    42 reviews

    The six-channel Micro Maestro raises the performance bar for serial servo controllers with features such as a native USB interface and internal scripting control. Whether you want high-performance servo control (0.25 μs resolution with built-in speed and acceleration control) or a general I/O controller (e.g. to interface with a sensor or ESC via your USB port), this tiny, versatile device will deliver.

    $44.99

  • Pololu 1645 Force-Sensing Resistor: 1.5" Square

    Pololu Pololu 1645 Force-Sensing Resistor: 1.5" Square

    This force-sensing resistor (FSR) from Interlink Electronics is a passive component that exhibits a decrease in resistance when there is an increase in the force applied to the 1.5″ נ1.5″ (4 cm נ4 cm) active area With a force sensitivity range of a few grams to a few kilograms, this sensor is optimized for use in human touch control applications

    $15.99

  • Pololu 1083 Universal Aluminum Mounting Hub for 6mm Shaft, #4-40 Holes

    Pololu Pololu 1083 Universal Aluminum Mounting Hub for 6mm Shaft, #4-40 Holes

    These universal mounting hubs are designed to work with most 6mm shafts, including round and 'D' shafts. Each hub has six mounting holes for 4-40 screws (not included), letting you mount custom wheels or mechanisms to your motors. 4-40 hex set screws (two included for each hub) allow secure coupling of shaft to hub. A 0.05' hex wrench (often the smallest size in SAE Allen wrench sets) is included for use with the set screws.

    $13.90


You have seen 48 out of 58 products

Electronic

Trending Products

Recently Viewed

© 2024 HardwareX Supply, Powered by Shopify

    • American Express
    • Apple Pay
    • Diners Club
    • Discover
    • Meta Pay
    • Google Pay
    • Mastercard
    • PayPal
    • Shop Pay
    • Venmo
    • Visa

    Login

    Forgot your password?

    Don't have an account yet?
    Create account