Nuk3y Door Saver II Hinge Pin Stop
- Bumperless design eliminates damage to doors and trim
- Ultra-low profile in four designer finishes
- Installs in seconds. No tools required
- Hinge mounted to fit all doors Made from strong carbon steel
- Works with 3" to 4-1/2" residential hinges with 1/4" diameter pin
hard to explain but the "stop" motion acts more like a spring and the door "bounces" back at us... not sure the aesthetic improvement is entirely worth it, but I'm too lazy to change it now...
Other door stops would have been difficult to install. This one was easy and it handles the door well.
So much better than other door stops Ive used. This is discreet and hard to even see once installed. Works great.
Installation took less than 5 minutes. Took me a minute to figure out how to set the cams, but got it set without too much trouble and it works like a charm.
Based on other reviews, I bought several of these to put in each hinge to decrease the chance that it would not be strong enough to hold back door. This turned out to be completely unnecessary as one per door was more than adequate. I used the bottom hinge because this pin will look different from your other pins and it is less noticeable if installed on lowest hinge. This pin is also longer than the average hinge so you will need to use a hack saw to cut off an inch or so. But that aside it worked perfectly and looks good. Would definitely use again.
We Also Recommend
Tower MFG 30440003 Auto-Reset 15 AMP Grounded 3-Prong GFCI 5-Outlet Adapter