$50 & Under

Great bang-for-the-buck driver can be used as a woofer, midbass, or even as a small subwoofer! Smooth frequency response up to 2 kHz and great bass response Rubber surround, aluminum voice coil, and extended bump plate Low 34 Hz free-air resonance

Read more less

Increase the realism of home theater and gaming systems for a more immersive experience Add low frequency tactile impact without ridiculous SPL levels Cast aluminum housing dissipates heat for reliable performance Attached 24” leads for easy connections in hard to reach installations Easy to install on any flat surface

Read more less

Aluminum former keeps voice coil cool for high power handling 1" diameter 4-layer voice coil improves power handling and low frequency response Extended pole piece creates symmetrical magnetic field for lower distortion Cosmetic low-profile mounting flange looks good without flush mounting Powerful motor for efficiency and compact enclosure

Read more less

Precision condenser microphone for critical measurement For use with any smartphone or tablet with a 3.5 mm TRRS headset jack True omnidirectional pattern with calibrated flat frequency response Headphone/Line Out pass-through jack for test signals or listening Kickstand feature elevates and angles device and microphone capsule

Read more less

Super small size with low profile height 8 ohm impedance for use in almost any amplifier Includes mounting plate Adds sound to any surface

Read more less

The PUCK by Dayton Audio is a small tactile transducer or mini bass shaker that is intended to be used in Home Theater, Gaming, and Auto Sound applications. Now includes convenient surface mounting kit for quick and easy installation onto any flat surface. Key Features Add a new level of impact to games, home theaters, and car audio systems Includes surface mounting ring for quick installation onto flat surfaces Add tactile feedback to chairs and couches for the ultimate gaming and movie experience Small and easy to install even when space is at a minimum

Read more less

Small size; just under 2" diameter, about 7/8" high Pre-applied 3M™ VHB™ adhesive for quick, durable installation Rare-earth neodymium motor and a proprietary voice coil 4-ohm impedance for use with small, Class D amplifiers 24 watt RMS power handling for high output

Read more less

Small size; just under 2" diameter, about 9/16" high Pre-applied 3M™ VHB™ adhesive for quick, durable installation Rare-earth neodymium motor and a proprietary voice coil 4-ohm impedance for use with small, Class D amplifiers 1" voice coil for 10 watt RMS power handling

Read more less

Poly damped woven glass fiber cone controls cone break-up and provides a smooth roll-off High energy ferrite magnet increases BL for higher efficiency and increased output Rubber surround improves cone linearity and transients Smooth response with true full-range reproduction for simple speaker designs

Read more less

Rigidly coupling a loudspeaker enclosure to a floor by means of a "spiking" system dramatically improves clarity, stereo imaging, and bass response. This is especially apparent with subwoofer systems. These attractive spikes are precision machined from solid brass and then plated with a durable finish. Barbed insert nuts and 6 mm threaded studs are included for mounting in cabinets with walls up to 1" thick. Set includes four cone spikes, four floor discs, four barbed insert nuts, and four threaded studs. Cone is 5/8", insert requires a 5/16" hole to be drilled prior to installation. • Dimensions: 9/16" diameter, 5/8" high (including disc).

Read more less

24kt. gold plating for best signal transfer and corrosion resistance 1-1/2" rear bolt mounts in speaker cabinets from 3/8" to 1" thick Large diameter knurled heads enable positive finger-tight connections Knurled shaft prevents post rotation

Read more less